how to jumpstart a car without another car

Skip to ContentSkip to Footer

How to jump start a car

Got a flat battery? This is how to jump start a car with jump leads or bump start it without them

Battery problems are one of the most common causes of car breakdowns, so there's a good chance that you'll at some point be stranded with a car that won't start. This will likely be because your car's battery has run flat, so knowing how to jump start your car and put some charge back into your battery is very handy – especially if you want to avoid a long wait for a breakdown callout.

A car battery can run out of charge for a few different reasons. For example, you can run the battery flat by leaving the radio or headlights on without the engine running, and your car may not start on a cold day as the lower temperatures will slow down the chemical reactions inside the battery cells. A battery will also over time lose its ability to hold onto its charge, so your car may refuse to start if the battery is a few years old.

Jump starting your car may look pretty simple on paper (boiled down to the basics, you're essentially just connecting one car's battery to another), but it is possible to make small mistakes with big consequences. Get it wrong, and you could cause damage to your car, and you may even risk giving yourself an electric shock. It's perhaps best to leave it to trained technicians if you're in any doubt, but our step-by-step guide below will show you how to safely jump start a car with a flat battery.

Jump start or bump start?

There are two common methods for starting a car which has a flat battery. One of these requires jump leads and another (running) car or a battery booster pack, while for the other you'll need to be able to get the car rolling to 'bump' start the engine.

Whichever way you do it, you should get your car battery checked as soon as possible after jump starting the car. If the battery was flat just because you left a light on then it should recover, but if it failed suddenly there could be an issue with the car's alternator or electrical system. It could be as simple as a dirty or corroded connection, though, so it's worth getting it checked out.

How to jump-start a car with jump leads:

1. Position the two cars:

Move another car close to the car with the flat battery (Car 1) so that the batteries are close together. In most cases, the car's battery will be in the engine bay, though some models have them mounted in the boot or even under a seat. Move all metal objects out of the way of both batteries and remove loose clothing and jewellery which could get caught in pulleys or cause a spark. Check that both batteries and your jump cables aren't damaged.

2. Connect the red jump lead:

Connect the red jump lead's crocodile clip to the positive (+) terminal on Car 2's battery, then the other end to the positive (+) terminal on Car 1's battery. Be careful not to touch the end of the clip to any other part of the car and make sure you are getting the terminal right. The positive terminal will be clearly marked and usually has a red cap.

3. Connect the black jump lead:

Connect the black jump lead's crocodile clip to the negative (-) terminal of Car 2's battery, then the other end to an earthing point on Car 1 – this is usually found at the end of the negative lead and is bolted to a solid part of the chassis.

4. Start the engine:

Start Car 2's engine. Wait about 5 minutes and then start Car 1. If the battery isn't totally dead and the car turns over slowly, you may be able to do this straight away. When the car is started, remove the clips in reverse order to the above.

5. Run or drive the car:

Run or, preferably, drive Car 1 for at least 15 minutes to let the battery recharge so that it can start on its own. Don't keep trying to start it though, or you will flatten the battery again.

Some models have inaccessible batteries and will usually have special terminals somewhere under the bonnet for jump starting – check the owner's manual if this is the case.

Without cables – the bump start (only works for manual cars)

If you are parked facing downhill, you won't need a push. But otherwise you'll need to gather some volunteers to help push your car.
Push in the clutch (do not release until step 4) and put the car into second gear. Turn on the ignition.
Have your friends start pushing the car, or let off the brakes if you're on a hill.
Once you're moving at a fast walking pace, bring up the clutch quickly and the engine will start. Once it does, push the clutch pedal again and let the engine idle. Let the car run while it recharges.

Jump starting a car with jump leads: explained in detail

1. Safety always comes first when dealing with electricity. Make sure that there are no metal objects nearby, like tools or even jewellery, that could come into contact with the batteries or cables - and take off any clothing that could get caught inside the engine bay.

You should also make sure that the batteries of both cars aren't damaged. If a battery's plastic casing is broken or it looks like it is leaking, don't try anything - either remove it yourself, if you know what you're doing, or take it to a professional to be replaced. Likewise, if the cables are damaged it may be best to borrow someone else's or buy some new ones - they're not too expensive.

2. After you've moved two cars close together so that the leads will reach between the batteries, it's time to connect the leads. Make sure both cars are completely off with the keys out and place a clip on the red jump cable onto the positive terminal - marked with a plus (+) symbol - on the battery of the car that works (we'll call this Car 2).

Clip the other end of the red cable to the positive (+) terminal on the non-starting car (Car 1). Make sure both clips are on securely and will not snap off. You should also make sure the cables don't fall into the engine bay and obstruct any moving parts.

3. Connect one end of the black jump lead to the negative terminal - marked with a minus (-) symbol - on Car 2's battery.

The other end of the black cable should be attached to an earthing point on Car 1 - some cars have a dedicated point, but otherwise use any bit of solid metal attached to the engine block or chassis, like an unpainted bolt. This should be away from the battery and any fuel-related parts. A small spark as you connect it is nothing to worry about.

4. Now start Car 2 and let the engine run for a little while. After about 5 minutes you should be able to start Car 1. If it doesn't start, then turn Car 2 off, gently adjust the clamps to ensure a good connection and then try again. If this doesn't work you may need a new battery or other essential parts to be repaired.

Once Car 1 is running, the clips can be removed. Make sure you don't touch any electrical components and only handle the insulated parts of the jump leads. Remove the leads in the opposite order to before: Earthed end of black lead, then the black clip on Car 2, then the red clip on Car 1, and finally the red clip on Car 2.

5. You will need to drive Car 1 or keep it running for at least 15 minutes to charge the battery up, but once it is running normally it can be driven as normal - just don't turn it off before the 15 minutes are up or you risk having to repeat the whole process!

How to bump-start a car without jump leads: detailed push start guide

1. Before you try push starting a car, you need to make sure it's a manual car with a clutch. Automatics or cars with no clutch can't be bump started.

You'll also need a group of friends to help you get the car moving. If you can't find any nearby, try asking some passers-by to help - they may even become your friends in the future, which would be a nice side-effect of having a flat battery. You could also be towed by another vehicle or, if you're on a hill and you can get the car moving without any help, you'll be able to start the car on your own.

2. Push in the clutch, and keep it depressed fully until step 4 (below). Put the car into second gear and turn the key so that the ignition light comes on.

3. Get your friends to start pushing the car, making sure that there is no traffic coming as you would when pulling off normally. If you're on a hill, let the brakes off so that you start moving.

4. Once you're on the move, at about 5mph, release the clutch quickly so that the engine and gearbox connect. The wheels will turn the gears and then the engine, starting the combustion cycle is the same way as your starter motor.

Come to a stop, leaving the engine running, and thank your companions for doing the legwork. Make sure you run the engine for at least 15 minutes to charge the battery before turning it off. You can use this time to make your friends a cup of tea, or simply drive away.

How to jump start a car with a portable power pack

Portable power packs are a way of starting a car without the extra effort of finding another car or a group of volunteers. These devices carry enough charge to jump start your car simply by attaching the built-in crocodile clips to your battery's positive terminal and to an earthing point - exactly like the steps for jump starting using another car (above). All you have to do then is turn the car on and remove the power pack, then leave the engine running to recharge the battery.

They tend to be quite a bit more expensive than jump leads, though power packs are a wise investment if you don't use your car very often or have a habit of leaving the lights on! They may also save you the bother of connecting up your car if another driver needs a jump start.

Check out our best mini jump starter packs here...

• Best winter tyres
• Winter driving tips
• Winter car checklist & best buys
• Hot new 4x4 cars coming soon
• Fact or fiction? 10 winter driving myths busted
• Best SUVs and 4x4s to buy now
• Best small 4x4s to buy now
• The world's coldest roads

Storing a car: how to lay up a car for the long term

Leaving a car unused for an extended period of time can be worrying, here's how you can keep your car in top condition while it's not in use.

8 Nov 2021

How to clean alloy wheels

Auto Express Product Awards 2016 - wheel cleaner

Tips & advice

How to clean alloy wheels

Alloy wheels can get dirty pretty quickly. Here's how you can keep them looking fresh with an alloy wheel cleaner.

2 Nov 2021

Best car polish

Best car polish - header

Car care

Best car polish

Restore a showroom shine to your paint with our best car polish top buys

18 Oct 2021

Best car wheel cleaner 2021

Best car wheel cleaner

Product group tests

Best car wheel cleaner 2021

Colour-changing car wheel cleaner sprays are hard-working grime busters

27 Sep 2021

Most Popular

Brand loyalty evaporates as car demand hits all-time high

News

Brand loyalty evaporates as car demand hits all-time high

Record demand for cars amid new and used supply shortages persuades buyers to abandon favourite brands

5 Nov 2021

Top 10 best hybrid cars to buy 2021

Best hybrid cars - header image

Hybrid cars

Top 10 best hybrid cars to buy 2021

Hybrid power is the way forward if the car industry is to be believed so we've found the top 10 best hybrid cars to buy now...

8 Nov 2021

New Porsche Panamera Platinum Edition launched from £83,510

Porsche Panamera Platinum Edition - front

Porsche Panamera

New Porsche Panamera Platinum Edition launched from £83,510

The Porsche Panamera Platinum Edition features more standard equipment and - you guessed it - platinum-coloured trim

8 Nov 2021

Skip to HeaderSkip to Content